ADSS Dead-end Fitting

ADSS dead-end fitting use: The dead-end fitting is mainly used for fixing and anchoring overhead self-supporting ADSS optical cable lines. It is generally installed in terminal towers, tight-line tension towers, corner towers, etc.
 
Composition: Each set of pre-twisted wire tension clamp components includes: inner stranded wire, outer stranded wire, and pull ring. Users can configure and purchase other connectors according to design requirements. Features: The grip strength of the pre-stranded wire clamp on the conductor (optical cable) can reach more than 95% of the ultimate tensile strength (R.T.S) of the conductor (optical cable), without the influence of stress concentration and vibration stress.
 
ADSS dead-end fittings, which acts as a strain clamp similar. Mainly used for 50-200m short span corners, tensile strength, terminal and other towers, not only suitable for overhead optical cables, but also for anchoring installation of overhead conductors, pull wires, etc., and used as traction clamps in optical cable construction. Simple structure, quick and convenient installation.
 
Composition: Single-layer strain clamp is composed of pre-twisted wire, pull ring, U-shaped ring, etc. Single-layer tension clamps can also be made of aluminum-clad steel wire or galvanized steel wire according to the use and user requirements.

More information about ADSS hardware fittings, pls contact us via Email: sales@ksdfibercable.com.


Post time: Oct-24-2021

Leave Your Message

Write your message here and send it to us